The RFX Race Series kill switches are OEM replacement parts.
Complete with the same fittings, fastenings, connectors, and cable lengths as the original part.
Available for a wide range of motorcycles.
Features:
- OEM replacement
- Accepts all original connectors
- OEM cable length
Installation instructions:
- Start by removing the front plate.
- Carefully cut the cable ties holding the start and stop switch cables on the handlebars, then unscrew the clamps and let them hang.
- Locate the switch connector on the bike; it is often near the steering column on the chassis but can sometimes be found under the tank.
- Detach the connector and remove the switch, noting the routing of the wiring.
- Clean the connector with an electrical contact cleaner.
- Lightly secure the new switch on the handlebars in the desired position.
- Route the wires as you did with the old switch and assemble the connector.
- Check that the wires are not taut by turning the handlebars fully; adjust if necessary.
- Reinstall the cable ties if possible, positioning the cables behind the handlebars to avoid damage from debris.
- Replace your front plate.
Specifications:
- weight (g): 50
- width (mm): 100
- height (mm): 40
- length (mm): 145
- volume (cm³): 580
